Faceted Star with Star Dust

 

sg701 star

Products Used

Bisque
  • MB-1499 Faceted Star

Color
  • SC-87 Ruby Slippers
  • SG-701 Star Dust

Decorating Accessories

  • RB-144 Soft Fan
  • MC-001 6mm Low Track Masking Tape 

Miscellaneous Accessories

  • X-ACTO Knife  

Designer: Elizabeth Carey
 

 

Instructions

1. Begin with a properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove dust.

2. Put the Faceted Star flat on the table, so that the small inner star is facing up. 

3. Using MC-001 6mm Low Track Masking Tape, tape off the inner star. Use an X-ACTO knife to trim off any excess. You don't want any tape on the inner star. 

4. Using the Soft Fan and SC-87 Ruby Slippers, apply three coats to the inner star. Allow glaze to dry between coats. Before the last coat of glaze is completely dry, carefully remove the tape. 

5. Leave the adjacent star facet as bisque. 

6. Using MC-001 6mm Low Track Masking Tape, tape off the next star facet. Use an X-ACTO knife to trim off any excess tape. 

7. Using the Soft Fan and SC-87 Ruby Slippers, apply three coats to the star. Allow glaze to dry between coats. Before the last coat of glaze is completely dry, carefully remove the tape. 

8. Repeat steps 5-7 until the entire star is complete. 

9. Make sure star is completely dry.

10. Using the Soft Fan and SG-701 Star Dust, apply two coats to the entire star. 

11. Fire to cone 06. 

custom-css-security